Dell PowerConnect 8024 릴리스 정보 - 페이지 11
{카테고리_이름} Dell PowerConnect 8024에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8024 20 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 8024에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지), 구성 매뉴얼 (21 페이지), 펌웨어 업그레이드 (24 페이지)
페이지 인쇄
Description
MLD Packets are not snooped, when
sending MLD packets with Hop-by-
Hop header with Router Alert Option.
Bridge multicast forbidden forward-
unregistered causes L3 Multicast to
fail.
Show interfaces advertise ethernet
<unit> <port> command is not parsed
properly.
'show interfaces switchport ethernet'
displays Egress Rule as "------" for
dynamic VLAN's.
User can not configure protocol based
vlans on lag interfaces.
FDB entries are not getting deleted on
MAB enabled port when the dotx state
is changed to force unauthorization
User with read-write access and with
enable authentication set as None is
not allowed to enter in to priviledge
mode.
Switch crashed when trying to
authenticate the Client using MAB
Device crashes when enabling
Dynamic Arp Inspection and
DHCPSnooping on out of range VLAN
Id.
IP Source Guard commands are not
available in port-channel mode
Ports fail to participate in GVRP VLAN
on receiving GVRP packet, even
though VLAN gets created.
Configured radius accounting
attributes do not reflect in running-
config.
System Firmware Version 3.1.4.16
PowerConnect 8024/8024F Release Notes
User Impact
Switch limitation such that it cannot
properly identify IPv6 MLD packets
that have the hop-by-hop option set.
Flooding in ingress VLAN.
No error message is printed if
Dynamic vlan is learned correctly. But
the show command "show interfaces
switchport ethernet <interface>"
command displays the dashed line in
place of participation strings when an
interface is participated in a dynamic
vlan.
User can not configure protocol based
vlans on lag interfaces.
The client MAC Address is still
present in the Forwarding Database
upon the Dot1x state change.
User is unable to login enable mode
when authentication method is none.
The switch reboots.
The switch reboots.
Cannot configure IP Source Guard on
port-channel interface via CLI.
GVRP registrations are not occurring.
Accounting Server name not
displayed in the running config.
Resolution
Added a new MLD rule to the FFP
which will trap to the CPU IPv6
Membership reports which use the
well known MAC address
33:33:00:00:00:16.
Modified the L3 interaction code of
snooping to notify the driver when
snooping is enabled. When
snooping is disabled, the current
operational state of snooping is also
sent to the driver.
Improved validation for invalid
interface.
Using different API to retrieve
tagging configuration of dynamic
vlan's versus static vlan's.
Updated to also allow protocol
based vlan's on LAG interfaces.
Corrected logic to clear FDB table
on setting the port state to force un-
authorized.
Corrected retreiving of user access
based on the username and index.
Modified driver layer to use a
semaphore to access the VLAN
shared data.
Corrected the validation for the valid
VLAN ID range in the Dynamic Arp
Inspection an DHCP Snooping
feature.
Addeed IP Source Guard CLI
commands for port-channel mode.
Synchronization between vlan
creation and vlan member
participation is addressed.
Updated running config to show
configured radius accouting
attributes.
Page 9