Dell PowerConnect 8024 릴리스 정보 - 페이지 12
{카테고리_이름} Dell PowerConnect 8024에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8024 20 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 8024에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지), 구성 매뉴얼 (21 페이지), 펌웨어 업그레이드 (24 페이지)
페이지 인쇄
PowerConnect 8024/8024F Release Notes
Description
Read-write user gets Read-only
access for telnet and SSH session,
when authentication method is
RADIUS.
Traffic matching with COS 7 is getting
dropped, when inbound MAC ACL is
configured on the interface with vlan
priority as 7.
Switch crashes when File System
page is accessed after configuring file
descriptor through CLI with more than
128 characters length.
Configured non-existing host cannot
be deleted for logging syslog
Able to successfully configure Banner
MOTD from WEB, but unable to
disable successfully.
Local user database does not accept
a user without a password from web,
although password minimum length is
disabled.
UDP data is not received by the
mrouter interface at egress vlan even
though L2 MFDB table showing both
join registered interface and mrouter
interface
Observed Internal BRCM_escape_lt;
brBRCM_escape_gt; words are
displayed on clicking Route
Redistribution Summary web page
Out Of Band Port status is shown as
UP, even though it's shutdown.
Huge running-config display hogs up
screen space with downloaded image
for captive poral
Page 10
User Impact
Read-write user gets Read-only
access for telnet and SSH session,
when authentication method is
RADIUS.
Traffic matching with COS 7 is getting
dropped, when inbound MAC ACL is
configured on the interface with vlan
priority as 7.
The switch reboots.
Only valid servers could be deleted by
the user.
Able to successfully configure Banner
MOTD from WEB, but unable to
disable successfully.
The Web would not accept the
username without a password which
was inconsistent with the CLI.
Querier attached interfaces will not
receive mcast data traffic
Irrelevant text displayed on the web
page.
Incorrect status communicated to the
user.
It's an inconvienence to the CLI user
for the need to scroll past unreadable
data.
Resolution
Use access level assigned by the
radius server instead of getting from
the local user database.
Corrected logic that configures vlan
priority as 6, when user is trying to
configure priority 7.
Increased buffer size to be 256.
Updated logic to remove non-
existing hosts also in CLI command
handler.
Added a checkbox in the web page
that to enable/disable MOTD
message.
Changed the text box property to
allow empty password also.
Add support for interfaces on which
queries are recevied.
Modified object handler code to
interpret html tags correctly.
Update the status in PHY, when
service port is shutdown
Remove all encoded binary and
Unicode from "show running-config".
Show encoded binary and Unicode
for show scripts (and show all)
commands.
Precede encoded binary and
Unicode with user notification
indiciating unreadable data.
Most encoded binary and Unicode
to the END of the show scripts (and
show all) command output.
System Firmware Version 3.1.4.16