Dell PowerConnect 8024F 구성 매뉴얼 - 페이지 13

{카테고리_이름} Dell PowerConnect 8024F에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8024F 21 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 8024F에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지), 릴리스 정보 (20 페이지), 구현 매뉴얼 (8 페이지), 펌웨어 업그레이드 (24 페이지)

페이지 인쇄

console(config)#ip http authentication local

console(config)#username admin password yourpassword privilege 15

console(config)#enable password yourpassword

3.9

Configure Jumbo Frames

console(config)#interface range tengigabitethernet all

console(config-if)#mtu 9216

console(config-if)#exit

3.10

Enable flow control

console(config)#flowcontrol

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to continue? (y/n)y

3.11

Configure spanning tree portfast on edge ports

console(config)#interface range tengigabitethernet 1/0/1-16

console(config-if)#spanning-tree portfast

console(config-if)#exit

3.12

Configure port channel for LAG

These commands configure the switch interconnect as a LAG.

console(conf)#interface port-channel 1

console(conf-if-po1)#mtu 9216

console(conf-if-po1)#exit

3.13

Configure SFP+ ports for LAG (M8024-k)

Note: The commands in this section assign the four built-in external 10Gb SFP+ ports to the Port

Channel on the M8024-k. If you have the M8024 switch, skip this step and proceed to Section 3.14.

console(conf)#interface range tengigabitethernet 1/0/17-20

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs