Dell PowerConnect 8024F Configuration Manual - Page 13
Browse online or download pdf Configuration Manual for Switch Dell PowerConnect 8024F. Dell PowerConnect 8024F 21 pages. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Also for Dell PowerConnect 8024F: Release Notes (27 pages), Release Notes (20 pages), Implementation Manual (8 pages), Upgrading Firmware (24 pages)
Print Page
console(config)#ip http authentication local
console(config)#username admin password yourpassword privilege 15
console(config)#enable password yourpassword
3.9
Configure Jumbo Frames
console(config)#interface range tengigabitethernet all
console(config-if)#mtu 9216
console(config-if)#exit
3.10
Enable flow control
console(config)#flowcontrol
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to continue? (y/n)y
3.11
Configure spanning tree portfast on edge ports
console(config)#interface range tengigabitethernet 1/0/1-16
console(config-if)#spanning-tree portfast
console(config-if)#exit
3.12
Configure port channel for LAG
These commands configure the switch interconnect as a LAG.
console(conf)#interface port-channel 1
console(conf-if-po1)#mtu 9216
console(conf-if-po1)#exit
3.13
Configure SFP+ ports for LAG (M8024-k)
Note: The commands in this section assign the four built-in external 10Gb SFP+ ports to the Port
Channel on the M8024-k. If you have the M8024 switch, skip this step and proceed to Section 3.14.
console(conf)#interface range tengigabitethernet 1/0/17-20
13
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs