Dell PowerConnect B-DCX-4S Backbone 교체 절차 - 페이지 3
{카테고리_이름} Dell PowerConnect B-DCX-4S Backbone에 대한 교체 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect B-DCX-4S Backbone 16 페이지. Power supply and filler
panel
Dell PowerConnect B-DCX-4S Backbone에 대해서도 마찬가지입니다: 교체 절차 (6 페이지)
페이지 인쇄In this guide
•
ESD precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
•
Replacing a PowerConnect B-DCX-4S Chassis . . . . . . . . . . . . . . . . . . . . . . . . 3
•
Cable routing table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
•
ESD precautions
The PowerConnect B-DCX-4S contains electrostatic discharge (ESD) sensitive FRUs. When working with any
PowerConnect B-DCX-4S FRU, use correct ESD procedures.
•
Wear a wrist grounding strap connected to chassis ground (if the PowerConnect B-DCX-4S is plugged in) or a
bench ground.
•
Store ESD-sensitive components in antistatic packaging.
Replacing a PowerConnect B-DCX-4S Chassis
This section describes how to remove and replace the PowerConnect B-DCX-4S chassis (with its backplane). The
basic steps are:
1.
2.
3.
4.
5.
6.
7.
8.
Reconnecting the system to the network and fabric
9.
NOTE
The PowerConnect B-DCX-4S must be removed from the fabric and powered off to perform this procedure. Contact
your support provider if you have any questions about whether the chassis requires replacement.
Time required
The chassis replacement takes approximately 3 hours.
PowerConnect B-DCX-4S Chassis Replacement Procedure
53-1001800-01
3