Dell PowerConnect BI-RX-8 시작하기 매뉴얼 - 페이지 25

{카테고리_이름} Dell PowerConnect BI-RX-8에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect BI-RX-8 32 페이지. Powerconnect b-rx series

Attaching a PC or terminal to the Console port or Ethernet port

The management module's Console port (which has a male DB-9 serial connector), and 10BaseT/100Base TX

Ethernet port (which has an RJ-45 UTP connector) allow you to attach a PC or terminal. From the Console port, you

can access the PowerConnect B-RX Series switch's CLI directly from the PC or terminal or through a Telnet

connection to the PC or terminal. From the Ethernet port, you can access the PowerConnect B-RX Series switch's CLI

or Web management interface directly from the PC or terminal or through a Telnet connection to the PC or terminal.

Before performing this task, you need the following items:

•

PC running a terminal emulation application or a terminal.

•

If connecting the PC or terminal to the Console port, a straight-through EIA or TIA DB-9 serial cable with one end

terminated in a female DB-9 connector and the other end terminated in a male or female DB-9 or DB-25

connector, depending on the specifications of your PC or terminal. You can order the serial cable separately from

Brocade or build your own cable. If you prefer to build your own, refer to your hardware installation guide.

•

If connecting the PC or terminal to the Ethernet port, a Category 5 UTP crossover cable, which you must supply.

For information about the management port pin assignments, refer to your hardware installation guide.

Follow the steps given below to attach a PC or terminal to the Console port or Ethernet port.

1. Connect a PC or terminal to the Console port or Ethernet port using the appropriate cable.

2. Open the terminal emulation program, and set the session parameters as follows:

•

Baud: 9600 bps

•

Data bits: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: None

Attaching the management module's Ethernet Port to a network

The management module's 10BaseT/100BaseTX/1000BaseTX Ethernet (management) port (RJ-45 UTP connector)

allows you to connect the management port to a network. A management station in your existing management

network can then access a PowerConnect B-RX Series switch using the switch's Network Manager.

To attach the management module's Ethernet port to a network, you need a Category 5 UTP straight-through cable

(not supplied by Dell). Connect one end of the straight-through cable to the management port and the other end to

the network.

Powering-on the power source

After you complete the hardware installation, you can power-on your power source.

1. Verify that all modules and power supplies are fully and properly installed and no module slots are uncovered.

CAUTION

If you do not install a module in a slot, you must keep the slot blank in place. If you run the chassis with

an uncovered slot, the system may overheat.

PowerConnect B-RX Series Getting Started Guide

53-1001682-03