Dell PowerConnect BI-RX-8 시작하기 매뉴얼 - 페이지 27
{카테고리_이름} Dell PowerConnect BI-RX-8에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect BI-RX-8 32 페이지. Powerconnect b-rx series
페이지 인쇄
Displaying the module status
After you have attached a PC or terminal to the management module's Console port or Ethernet port and the
PowerConnect B-RX Series switch has initialized successfully, press Enter to display the following CLI prompt in the
terminal emulation window:
BigIron RX>
If you do not see this prompt, do the following.
1. Make sure the cable is securely connected to your PC or terminal and the Console port or Ethernet port.
2. Check the settings in your terminal emulation program. In addition to the session settings listed in
PC or terminal to the Console port or Ethernet port"
running on the same serial port you attached to the Console port.
If you see this prompt (BigIron RX>), you are now connected to the system and can display the status of the modules
using the CLI. Enter the following command at any CLI level:
BigIron RX# show module
Module
M1 (upper): BigIron RX Mgmt Module
M2 (lower):
F0: BigIron RX Switch Fabric Module
S1:
S2:
S3:
S4: BigIron RX 4-Port 10Gig Module
S5: BigIron RX 4-Port 10Gig Module
S6: BigIron RX 4-Port 10Gig Module
S7:
S8:
Assigning passwords
DANGER
The procedures in this manual are for qualified service personnel.
Passwords can be up to 48 characters long. When you create an enable and a user password, you must enter a
minimum of eight characters containing the following combinations:
•
At least two upper case characters
•
At least two lower case characters
•
At least two numeric characters
•
At least two special characters
When you create a password, the characters you type are masked.
For example, to create a password for the enable login:
BigIron RX (config)#enable password TesT12$!
PowerConnect B-RX Series Getting Started Guide
53-1001682-03
on page 25, make sure the terminal emulation session is
Status
Ports
Active
Active
CARD_STATE_UP
4
000c.db80.0000
CARD_STATE_UP
4
000c.db80.0000
CARD_STATE_UP
4
000c.db80.0000
Starting MAC
"Attaching a
27