Dell PowerConnect M8024-k 구성 매뉴얼 - 페이지 13

{카테고리_이름} Dell PowerConnect M8024-k에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect M8024-k 21 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect M8024-k에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지), 펌웨어 업그레이드 (24 페이지)

페이지 인쇄

console(config)#ip http authentication local

console(config)#username admin password yourpassword privilege 15

console(config)#enable password yourpassword

3.9

Configure Jumbo Frames

console(config)#interface range tengigabitethernet all

console(config-if)#mtu 9216

console(config-if)#exit

3.10

Enable flow control

console(config)#flowcontrol

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to continue? (y/n)y

3.11

Configure spanning tree portfast on edge ports

console(config)#interface range tengigabitethernet 1/0/1-16

console(config-if)#spanning-tree portfast

console(config-if)#exit

3.12

Configure port channel for LAG

These commands configure the switch interconnect as a LAG.

console(conf)#interface port-channel 1

console(conf-if-po1)#mtu 9216

console(conf-if-po1)#exit

3.13

Configure SFP+ ports for LAG (M8024-k)

Note: The commands in this section assign the four built-in external 10Gb SFP+ ports to the Port

Channel on the M8024-k. If you have the M8024 switch, skip this step and proceed to Section 3.14.

console(conf)#interface range tengigabitethernet 1/0/17-20

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs