Dell PowerConnect M8024-k Configuratiehandleiding - Pagina 13

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Dell PowerConnect M8024-k. Dell PowerConnect M8024-k 21 pagina's. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Ook voor Dell PowerConnect M8024-k: Release-opmerkingen (27 pagina's), Firmware upgraden (24 pagina's)

Dell PowerConnect M8024-k Configuratiehandleiding
console(config)#ip http authentication local
console(config)#username admin password yourpassword privilege 15
console(config)#enable password yourpassword
3.9

Configure Jumbo Frames

console(config)#interface range tengigabitethernet all
console(config-if)#mtu 9216
console(config-if)#exit
3.10

Enable flow control

console(config)#flowcontrol
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to continue? (y/n)y
3.11

Configure spanning tree portfast on edge ports

console(config)#interface range tengigabitethernet 1/0/1-16
console(config-if)#spanning-tree portfast
console(config-if)#exit
3.12

Configure port channel for LAG

These commands configure the switch interconnect as a LAG.
console(conf)#interface port-channel 1
console(conf-if-po1)#mtu 9216
console(conf-if-po1)#exit
3.13

Configure SFP+ ports for LAG (M8024-k)

Note: The commands in this section assign the four built-in external 10Gb SFP+ ports to the Port
Channel on the M8024-k. If you have the M8024 switch, skip this step and proceed to Section 3.14.
console(conf)#interface range tengigabitethernet 1/0/17-20
13
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs