Dell PowerConnect W-651 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} Dell PowerConnect W-651에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect W-651 8 페이지. Arubaos 6.1
페이지 인쇄Table 3
Console Prompt
Enter VLAN 1 interface subnet mask
Enter IP Default gateway
Enter Switch Role, (master|local)
(For US controllers only)
This controller is restricted to Country
code US for United States, please confirm
(yes|no)
Enter Time Zone
Enter Time in UTC
Enter Date (MM/DD/YYYY)
Enter Password for admin login (up to 32
chars)
Enter Password for enable mode (up to 15
chars
Do you wish to shutdown all the ports
(yes|no)? [no]
5. At the end of the Initial Setup, you are asked to review and confirm your configuration changes. Enter y to
accept the changes. The controller reboots.
NOTE: If you want to complete optional configuration options (e.g. disabling spanning tree or installing software licenses) before
connecting the controller to the network, refer to the Dell PowerConnect W-Series ArubaOS User Guide for additional information
on controller configuration.
Connect the Controller to the Wired Network
Once controller setup is complete, connect a port on the controller to the appropriately-configured port on a
Layer-2 switch or router. Make sure that you have the correct cables and that the port LEDs indicate proper
connections. Refer to the Installation Guide for your Dell controller for port LED and cable descriptions.
Configure the Controller to Support APs
Before you install APs in a network environment, you must ensure that the APs will be able to locate and connect
to the controller when powered on. Specifically, you need to ensure the following:
When connected to the network, each AP is assigned a valid IP address
APs are able to locate the controller
4
Console Configuration Setup Information (Continued)
Description
Enter the VLAN 1 interface IP subnet mask, or press Enter without specifying an IP
address to use the default address 255.255.255.0.
This is usually the IP address of the interface on the upstream switch or router to
which you will connect the controller. The default gateway and the VLAN 1 IP
address need to be in the same network. To continue without specifying an IP
gateway, press Enter.
Enter one of the following switch roles:
Master: This controller will manage other controllers on the network. This is the
default setting.
Local: This controller will be managed by a master controller. You are prompted
for a key that will be used by all controllers on the network. (You need to
provide the IP address of the master controller.)
If your controller has a country code that restricts its usage, enter yes to confirm
this code.
Enter the time zone for the controller, or press Enter to select the default time zone.
Enter the current time in UTC format, or press Enter to select the default time.
Enter the current date, or press Enter to select the default date.
Enter a password to allow the admin user to login to the controller WebUI, CLI and
console interfaces. This password can be up to 32 alphanumeric characters long.
Enter a password for the admin user to access Enable mode in the controller
WebUI, CLI and console interfaces. This password can be up to 15 alphanumeric
characters long.
Enter yes to shut down all ethernet ports on the controller, or press Enter to allow
all ports to remain active.
Dell PowerConnect W-Series | ArubaOS 6.1 Quick Start Guide