Dell PowerConnect W-651 Snelstarthandleiding - Pagina 4

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dell PowerConnect W-651. Dell PowerConnect W-651 8 pagina's. Arubaos 6.1

Pagina afdrukken

Table 3

Console Prompt

Enter VLAN 1 interface subnet mask

Enter IP Default gateway

Enter Switch Role, (master|local)

(For US controllers only)

This controller is restricted to Country

code US for United States, please confirm

(yes|no)

Enter Time Zone

Enter Time in UTC

Enter Date (MM/DD/YYYY)

Enter Password for admin login (up to 32

chars)

Enter Password for enable mode (up to 15

chars

Do you wish to shutdown all the ports

(yes|no)? [no]

5. At the end of the Initial Setup, you are asked to review and confirm your configuration changes. Enter y to

accept the changes. The controller reboots.

NOTE: If you want to complete optional configuration options (e.g. disabling spanning tree or installing software licenses) before

connecting the controller to the network, refer to the Dell PowerConnect W-Series ArubaOS User Guide for additional information

on controller configuration.

Connect the Controller to the Wired Network

Once controller setup is complete, connect a port on the controller to the appropriately-configured port on a

Layer-2 switch or router. Make sure that you have the correct cables and that the port LEDs indicate proper

connections. Refer to the Installation Guide for your Dell controller for port LED and cable descriptions.

Configure the Controller to Support APs

Before you install APs in a network environment, you must ensure that the APs will be able to locate and connect

to the controller when powered on. Specifically, you need to ensure the following:

When connected to the network, each AP is assigned a valid IP address



APs are able to locate the controller



Console Configuration Setup Information (Continued)

Description

Enter the VLAN 1 interface IP subnet mask, or press Enter without specifying an IP

address to use the default address 255.255.255.0.

This is usually the IP address of the interface on the upstream switch or router to

which you will connect the controller. The default gateway and the VLAN 1 IP

address need to be in the same network. To continue without specifying an IP

gateway, press Enter.

Enter one of the following switch roles:



Master: This controller will manage other controllers on the network. This is the

default setting.



Local: This controller will be managed by a master controller. You are prompted

for a key that will be used by all controllers on the network. (You need to

provide the IP address of the master controller.)

If your controller has a country code that restricts its usage, enter yes to confirm

this code.

Enter the time zone for the controller, or press Enter to select the default time zone.

Enter the current time in UTC format, or press Enter to select the default time.

Enter the current date, or press Enter to select the default date.

Enter a password to allow the admin user to login to the controller WebUI, CLI and

console interfaces. This password can be up to 32 alphanumeric characters long.

Enter a password for the admin user to access Enable mode in the controller

WebUI, CLI and console interfaces. This password can be up to 15 alphanumeric

characters long.

Enter yes to shut down all ethernet ports on the controller, or press Enter to allow

all ports to remain active.

Dell PowerConnect W-Series | ArubaOS 6.1 Quick Start Guide