Dell PowerEdge M420 릴리스 정보 - 페이지 24

{카테고리_이름} Dell PowerEdge M420에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M420 27 페이지. Dell poweredge blade servers getting started guide
Dell PowerEdge M420에 대해서도 마찬가지입니다: 정보 업데이트 (38 페이지), 매뉴얼 (25 페이지), 사용자 설명서 (23 페이지), 중요 정보 매뉴얼 (35 페이지), 업데이트 매뉴얼 (32 페이지), 업데이트 매뉴얼 (28 페이지), 사용자 설명서 (26 페이지), 사용자 설명서 (22 페이지), 시작하기 매뉴얼 (12 페이지), 매뉴얼 (38 페이지), 기술 매뉴얼 (46 페이지), 기술 매뉴얼 (48 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (12 페이지)

Summary

User Impact

Non-configuration file

Switch does not utilize invalid configuration file

getting loaded to

information. Earlier versions of startup-config

startup-config through

are not available for fallback when overwritten

HTTP.

with an invalid startup-config.

A v6 ping with the v4

Users are not able to ping over 6to4 tunnels using

header destination

IPv6 addresses.

address set to 224.0.0.2

(all routers addr) is not

responded to.

Certain packets match

Packets may be transmitted out of order when

system rules that elevate

using priority flow control. Additionally, if the

the priority for protocol

queue that the packets are put on is not enabled

packets.

for lossless PFC, then the packets can be

transmitted even when the port was told to pause.

This may have an effect on connections that

expect packet order to be maintained, e.g. FCoE.

Workaround

In this case, an invalid configuration file was

downloaded (on purpose) via the web. When

the switch rebooted, it detected that the

configuration file was invalid and overwrote

the start-up config with the default

configuration (an empty configuration). Users

are advised to maintain off-line copies of

switch configurations.

Users can send pure IPv4 pings to the other

end of the tunnel.

None.

System Firmware Version 4.1.0.6