AVX BTA-1000 사용자 설명서 - 페이지 6
{카테고리_이름} AVX BTA-1000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVX BTA-1000 7 페이지. Bluetooth stereo amplifier
페이지 인쇄Additional Information / Troubleshooting
*Please refer to the chart below if your amplifier is not functioning properly. In the event
you are experiencing an issue not outlined below, please contact an authorized AVX Audio
dealer to obtain further support.
PROBLEM
THE UNIT
FAILS TO
TURN ON
NO SOUND
SOUND
SUDDENLY
GOES OFF
THERE IS A
LACK OF
BASS
REMOTE
CONTROL
DOES NOT
FUNCTION
PROPERLY
CAUSE
The power cable is not
connected or the plug
is not completely inserted.
Protection Circuitry has
been activated because of
a short circuit.
Incorrect output or input
cable connections
Speaker A/B selector is
not set properly.
Speaker output has been
muted.
The connected component
is not playing.
The unit has become too hot
and has gone into protection
mode.
Amplifier has turned off
Speakers are connected out
of phase / + and - is reversed
The batteries are weak or
not inserted
REMEDY
Connect the power cable firmly
Check and confirm speaker
wires are not touching and then
turn power back on.
Verify cables are connected
properly, if problem persists
cables may be defective
Confirm Speaker A/B selector
is set to the appropriate output
that speakers are connected to
Disable the mute function.
Verify component is connected
to the corresponding input
that is being selected.
Make sure the openings on the
top panel are not covered.
Allow unit to cool.
Verify speaker connections are
not touching one another. This
will cause a short circuit.
Connect the speaker wires to
the correct + and - phase.
Replace all batteries.
5