AVX BTA-1000 Kullanıcı Kılavuzu - Sayfa 6

Amplifikatör AVX BTA-1000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AVX BTA-1000 7 sayfaları. Bluetooth stereo amplifier

Sayfayı Yazdır

Additional Information / Troubleshooting

*Please refer to the chart below if your amplifier is not functioning properly. In the event

you are experiencing an issue not outlined below, please contact an authorized AVX Audio

dealer to obtain further support.

PROBLEM

THE UNIT

FAILS TO

TURN ON

NO SOUND

SOUND

SUDDENLY

GOES OFF

THERE IS A

LACK OF

BASS

REMOTE

CONTROL

DOES NOT

FUNCTION

PROPERLY

CAUSE

The power cable is not

connected or the plug

is not completely inserted.

Protection Circuitry has

been activated because of

a short circuit.

Incorrect output or input

cable connections

Speaker A/B selector is

not set properly.

Speaker output has been

muted.

The connected component

is not playing.

The unit has become too hot

and has gone into protection

mode.

Amplifier has turned off

Speakers are connected out

of phase / + and - is reversed

The batteries are weak or

not inserted

REMEDY

Connect the power cable firmly

Check and confirm speaker

wires are not touching and then

turn power back on.

Verify cables are connected

properly, if problem persists

cables may be defective

Confirm Speaker A/B selector

is set to the appropriate output

that speakers are connected to

Disable the mute function.

Verify component is connected

to the corresponding input

that is being selected.

Make sure the openings on the

top panel are not covered.

Allow unit to cool.

Verify speaker connections are

not touching one another. This

will cause a short circuit.

Connect the speaker wires to

the correct + and - phase.

Replace all batteries.