Dell S3100 Series 시작하기 매뉴얼 - 페이지 35

{카테고리_이름} Dell S3100 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S3100 Series 46 페이지.
Dell S3100 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (45 페이지), 시작하기 매뉴얼 (27 페이지)

페이지 인쇄
Dell S3100 Series 시작하기 매뉴얼
Figure 26. Installing the Switch in a Front-Rack Configuration

Connecting the Stacking Ports (Optional)

For the S3124P or S3148P platforms, you can connect up to six switches to operate as a single unit, using
two fixed mini-SAS stacking connectors on the PSU side. When you connect multiple switches together
through the stack ports, they operate as a single unit with up to 288 front panel ports. The stack operates
and is managed as a single entity.
NOTE: The S3124P and S3148P platforms support stacking with Dell Networking OS 9.8(2.0). Stacks
must be either all S3124P or S3148P platforms, you cannot combine different platforms into one
stack. The S3124 and S3124F platforms do not support stacking with Dell Networking OS 9.8(2.0).
Dell recommends installing the switches connected in a ring topology. Assemble and cable the stack of
switches before powering up and configuring it.
To install your switches in a ring topology, follow these steps.
1.
Connect one of the mini-SAS cables into either of the stacking ports of the top switch and the switch
directly below it. As necessary, use a separately purchased, longer (1 meter or 3 meter) mini-SAS
cable to connect the switches.
2.
Repeat this process until all the devices are connected.
3.
Use the remaining stacking cable to connect the two remaining stacking ports together so that a ring
topology is assembled.
Installation
35