Dell S4048-ON 구성 매뉴얼 - 페이지 20

{카테고리_이름} Dell S4048-ON에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S4048-ON 30 페이지. Enterprise switches
Dell S4048-ON에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 문제 해결 매뉴얼 (29 페이지)

페이지 인쇄

Switch configuration (OS 10.x)

3.1.7

Enable switch ports

Switch ports are enabled and are configured for switchport mode access by default for S4048 switches. If

choosing to reconfigure the ports, use the following steps.

Option 1: Enable ports individually by entering the port number.

OS10# configure terminal

OS10(config)#interface ethernet 1/1/1

Note: For ports configured as 4 x 10GbE breakout ports, use the following command in which 1/1 represents

the switch number, <xx> represents the port number, and <yy> represents sub port number:

OS10(conf)#interface range ethernet 1/1/<xx>:<yy>

OS10(conf-if-eth1/1/1)# switchport mode access

OS10(conf-if-eth1/1/1)# no shutdown

OS10(conf-if-eth1/1/1)# exit

Option 2: Enable multiple ports at once using the range parameter.

OS10# configure terminal

OS10(config)# interface range ethernet 1/1/1–1/1/48

Note: For ports configured as 4 x 10GbE breakout ports, use the following command in which 1/1 represents

the switch number, <xx> represents the port number, and <yy> represents sub port number:

OS10(conf)#interface range ethernet 1/1/<xx>:<yy>-1/1/<xx>:<yy>

OS10(conf-range-eth1/1/1-1/1/48)# switchport

OS10(conf-range-eth1/1/1-1/1/48)# no shutdown

OS10(conf-range-eth1/1/1-1/1/48)# exit

3.1.8

iSCSI enable

This section describes enabling iSCSI auto-detection of attached storage arrays and switch auto-

configuration. PS Series and Dell EMC SC Series storage arrays will be detected by the switch when iscsi is

enabled. The switch will auto-configure for Jumbo frames with MTU 9216 and flowcontrol receive on, transmit

off for all the ports. The ports detected to be connected to the above storage units will be auto-configured as

spanning-tree edge ports and unicast storm control is disabled.

OS10(config)# iscsi enable

OS10(config)# iscsi session-monitoring enable

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026