Dell S4048-ON Посібник з конфігурації - Сторінка 20

Переглянути онлайн або завантажити pdf Посібник з конфігурації для Перемикач Dell S4048-ON. Dell S4048-ON 30 сторінок. Enterprise switches
Також для Dell S4048-ON: Посібник з конфігурації (19 сторінок), Посібник з усунення несправностей (29 сторінок)

Switch configuration (OS 10.x)

3.1.7

Enable switch ports

Switch ports are enabled and are configured for switchport mode access by default for S4048 switches. If

choosing to reconfigure the ports, use the following steps.

Option 1: Enable ports individually by entering the port number.

OS10# configure terminal

OS10(config)#interface ethernet 1/1/1

Note: For ports configured as 4 x 10GbE breakout ports, use the following command in which 1/1 represents

the switch number, <xx> represents the port number, and <yy> represents sub port number:

OS10(conf)#interface range ethernet 1/1/<xx>:<yy>

OS10(conf-if-eth1/1/1)# switchport mode access

OS10(conf-if-eth1/1/1)# no shutdown

OS10(conf-if-eth1/1/1)# exit

Option 2: Enable multiple ports at once using the range parameter.

OS10# configure terminal

OS10(config)# interface range ethernet 1/1/1–1/1/48

Note: For ports configured as 4 x 10GbE breakout ports, use the following command in which 1/1 represents

the switch number, <xx> represents the port number, and <yy> represents sub port number:

OS10(conf)#interface range ethernet 1/1/<xx>:<yy>-1/1/<xx>:<yy>

OS10(conf-range-eth1/1/1-1/1/48)# switchport

OS10(conf-range-eth1/1/1-1/1/48)# no shutdown

OS10(conf-range-eth1/1/1-1/1/48)# exit

3.1.8

This section describes enabling iSCSI auto-detection of attached storage arrays and switch auto-

configuration. PS Series and Dell EMC SC Series storage arrays will be detected by the switch when iscsi is

enabled. The switch will auto-configure for Jumbo frames with MTU 9216 and flowcontrol receive on, transmit

off for all the ports. The ports detected to be connected to the above storage units will be auto-configured as

spanning-tree edge ports and unicast storm control is disabled.

OS10(config)# iscsi enable

OS10(config)# iscsi session-monitoring enable

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026