Dell Z9000 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} Dell Z9000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Z9000 27 페이지. Z9000 system
Dell Z9000에 대해서도 마찬가지입니다: 매뉴얼 (48 페이지)

The SYS LED does not light up until the boot-up sequence is complete. When

the boot-up is complete, the SYS LED is steadily lit green.

AC Power

Connect the plug to each AC power connector. Make sure the power cord is

secure.

As soon as the cable is connected between the Z9000 and the power source, the

system is powered-up; there is no on/off switch.

DC Power

To connect the DC power connector, follow these steps:

Step

Task

Remove the small plastic cover from the DC connectors.

Ensure that the power source is turned off. Do not attach the DC cable to

the DC connectors while the power source is on.

Attach the connectors to the PSUs. Make sure the connections are

secure.

Replace the plastic cover over the DC connectors.

As soon as the cable is connected between the Z9000 and the power source, the

chassis is powered-up; there is no on/off switch.

Fans

The Z9000 system comes from the factory with one PSU and four fan modules

installed in the chassis. If two or more fans are installed and running, the fan

modules are hot-swappable.

The fan speed increases and decreases automatically based on the system's state

and temperature. The switch never intentionally turns off the fans. To see the log

messages, use the show logging command.

Installing the Hardware