EarthQuake Cinenova 7300 사용자 설명서 - 페이지 9
{카테고리_이름} EarthQuake Cinenova 7300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake Cinenova 7300 12 페이지. 7 channel, class ab amplifier
페이지 인쇄
Troubleshooting The Cinénova 7300
Peak LEDs "ON" Constantly
It is normal when running the amplifier to full power that the LED's flicker. If the LED's
are on constantly without flickering (solid orange) it means that the amplifier output is
clipping. Reduce volume level to prevent damage to speakers or amplifier.
Humming Noise From Speakers
Often humming noise is emanating from equipment that have their ground prong broken.
To isolate this problem:
a) With the amplifier OFF, unplug all RCA's connected to the amp.
b) Turn on amp and listen to speakers. If buzz has changed or reduced in level, then the
problem is coming to the amp from another source. The rest of the hum you hear is
normal and related to the fact that the RCA's are open ended.
c) The above step should isolate your problem: star-ground all components, except
amplifier, by daisy-chaining a thin wire from the processors chassis to all sources
connected to it.
Maintenance
The following maintenance should be performed routinely:
Clean the exterior surfaces of the unit with a soft, dry, lint-free cloth.
�
Do not use alcohol, benzene, acetone-based cleaners, or strong
�
commercial cleaners.
Do not use a cloth made with steel wool or metal polish.
�
If the unit is exposed to a dusty environment, a low-pressure blower
�
may be used to remove dust from its interior & exterior.
Circuit Protection
The Cinénova 7300 is protected with optical short circuit protection. If it is tripped, the
shorted channel will mute and reset every 7 seconds. If fault remains, it will stay in mute
mode. We recommend to swap the speaker with a guaranteed working speaker and see
if the channel works.
www.earthquakesound.com
If Problems Persist
Contact Earthquake Sound Technical Service
Phone: 1-800-576-7944 or 510-732-1000
Email: [email protected]
9