EarthQuake Cinenova 7300 사용자 설명서 - 페이지 7
{카테고리_이름} EarthQuake Cinenova 7300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake Cinenova 7300 12 페이지. 7 channel, class ab amplifier
페이지 인쇄
Getting Started With The Cinénova 7300
Confirm the voltage setting of the amplifier. It must match the voltage in your
home. The amp is set by factory to either 120V or 240V. Check above the circuit
breaker for this information.
Amplification Block Plate
O CZ
O K P
www.earthquakesound.com
Power Plate
1) INPUT SELECTION
Set the input control to either RCA or XLR. This
tells the amp which input type will be used.
3) 12VDC
WHEN APPLICABLE
If you plan to power the Cinénova 7300 using
an external source, then you will need to plug
the source into the 12VDC Trigger.
When using this feature the main power switch
must remain in the OFF position at all times.
2) SPEAKER CONNECTIONS
A pair of binding posts
is provided for each
channel. These posts
accept bare wire,
spade lugs & banana
type plugs. If bare wire
is used then strip ap-
proximately 1/2 inch to
3/4 inch of insulation
from the end of each
wire and carefully twist
the strands of each
conductor together.
Then insert.
4) PLUG IN POWER CORD
Plug the AC power cord
into the amp first then into
the wall outlet. Make sure
it is firmly connected.
The fuse holder is located directly under the
power socket. It contains one extra 15 am-
pere, 250V fuse.
To access the fuse holder, make sure your
Cinénova is turned off and unplugged from
both the wall outlet and the amplifier's power
socket. Place a flat head screwdriver in the
groove on the top of the fuse holder and sim-
ply pry off the fuse holder.
7