EarthQuake mini D2000 설치 매뉴얼 - 페이지 4

{카테고리_이름} EarthQuake mini D2000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake mini D2000 13 페이지. Mini d amp
EarthQuake mini D2000에 대해서도 마찬가지입니다: 설치 매뉴얼 (7 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

mini D ImpUri!.

FUNCTIONS AND FEATURES

mini

DIOOO

mini

DtOOO

mini

Dt500

POWER LED: When lit up, the amplifier is functioning properly

(]) PROTECTION LED: When lit up upon powering on, the

amplifier

may be in self

test mode

Ifthis LED stays on, shut down the amplifier and locate what may

have triggered the amplifier to protection mode. If problem persists, cali us

for further assistance.

REMOTE SUB LEVEL: Used to adjust the amplifier's bass output fram a

location ofyour choice.

RCA INPUT: Low level inputs with range of O.1V to 5V RMS. Be sure to use a

HIGH LOW LEVEL adaptor ifthe hear unit has only speaker output.

BRIDGE IN/OUT: Used when linking 2 amplifiers together. The BRIDGE 11\1

receives signal from the master

amplifier

and should only be used when the

amplifier is the slave amplifier (ali functions of the slave amplifier will be

adjusted by the master amplifier)

The BRIDGE OUT sends signal to the

slave amplifier and should only be used when the amplifier is the master

amplifier.

Note that both bridged amplifiers must be of the same model

with minimum impedance is 2-0hm

GAIN

CONTROL:

Set based on the head unit's output voltage.

Note,

this is not

a volume control. Always start at the MIN and slowly increase the gain.

Stop as soon as distortion is heard then lower the gain until the distortion

disappear and only c1ear sound is produced

(])

LPF (LOW PASS FILTER): Used to filter out unwanted mid and

high

frequencies

SUBSONIC FILTER: Used to protect the speakers from harmful low

frequencies and DC Voltage. The best

setting

for most system is at 30Hz (2

o'clock position).

Specifications are subject to change without notice