EarthQuake mini D2000 Installatiehandleiding - Pagina 4
Blader online of download pdf Installatiehandleiding voor {categorie_naam} EarthQuake mini D2000. EarthQuake mini D2000 13 pagina's. Mini d amp
Ook voor EarthQuake mini D2000: Installatiehandleiding (7 pagina's), Installatiehandleiding (16 pagina's)
Pagina afdrukken
mini D ImpUri!.
FUNCTIONS AND FEATURES
mini
DIOOO
1
mini
DtOOO
mini
Dt500
CD
POWER LED: When lit up, the amplifier is functioning properly
.
(]) PROTECTION LED: When lit up upon powering on, the
amplifier
may be in self
test mode
.
Ifthis LED stays on, shut down the amplifier and locate what may
have triggered the amplifier to protection mode. If problem persists, cali us
for further assistance.
@
REMOTE SUB LEVEL: Used to adjust the amplifier's bass output fram a
location ofyour choice.
8)
RCA INPUT: Low level inputs with range of O.1V to 5V RMS. Be sure to use a
HIGH LOW LEVEL adaptor ifthe hear unit has only speaker output.
®
BRIDGE IN/OUT: Used when linking 2 amplifiers together. The BRIDGE 11\1
receives signal from the master
amplifier
and should only be used when the
amplifier is the slave amplifier (ali functions of the slave amplifier will be
adjusted by the master amplifier)
.
The BRIDGE OUT sends signal to the
slave amplifier and should only be used when the amplifier is the master
amplifier.
Note that both bridged amplifiers must be of the same model
with minimum impedance is 2-0hm
.
®
GAIN
CONTROL:
Set based on the head unit's output voltage.
Note,
this is not
a volume control. Always start at the MIN and slowly increase the gain.
Stop as soon as distortion is heard then lower the gain until the distortion
disappear and only c1ear sound is produced
.
(])
LPF (LOW PASS FILTER): Used to filter out unwanted mid and
high
frequencies
.
®
SUBSONIC FILTER: Used to protect the speakers from harmful low
frequencies and DC Voltage. The best
setting
for most system is at 30Hz (2
o'clock position).
Specifications are subject to change without notice
4