EarthQuake 9800 Series 운영자 매뉴얼 - 페이지 7
{카테고리_이름} EarthQuake 9800 Series에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake 9800 Series 13 페이지. Two-man earth auger powerhead
EarthQuake 9800 Series에 대해서도 마찬가지입니다: 운영자 매뉴얼 (16 페이지), 운영자 매뉴얼 (19 페이지), 운영자 매뉴얼 (20 페이지)
페이지 인쇄
MAINTENANCE AND STORAGE
STORAGE
CAUTION
Do not store auger with fuel in tank indoors or in
enclosed, poorly ventilated areas, where fuel fumes
may reach an open flame, spark, pilot light or an
ignited object. Drain fuel outdoors away from any
ignition sources. Use only approved fuel containers.
CAUTION
FOR LONG TERM STORAGE:
Close fuel shut-off valve and
store powerhead in an
upright position. Failure to
do so can cause oil leakage
over a prolonged period.
Follow the steps below to prepare your auger for storage.
Read your engine manual for detailed instructions on
preparing the engine for storage.
1. Run with gas stabilizer in fuel. Screen in carburetor will
glaze shut if gas stabilizer is not used before storage.
2. Drain the fuel system. Run the engine until it stops.
3. Change oil.
4. Remove spark plug, pour one (1) ounce of clean engine
oil into spark plug hole. Cover hole with a rag. Pull
starter handle slowly several times to distribute oil.
Install spark plug. Do not connect spark plug wire.
5. Clean entire auger.
6. Store your auger in a clean, dry building that is
inaccessible to children.
Page 7
ARDISAM