EarthQuake 9800 Series Manuel de l'opérateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} EarthQuake 9800 Series. EarthQuake 9800 Series 13 pages. Two-man earth auger powerhead
Également pour EarthQuake 9800 Series : Manuel de l'opérateur (16 pages), Manuel de l'opérateur (19 pages), Manuel de l'opérateur (20 pages)
Imprimer la page
MAINTENANCE AND STORAGE
STORAGE
CAUTION
Do not store auger with fuel in tank indoors or in
enclosed, poorly ventilated areas, where fuel fumes
may reach an open flame, spark, pilot light or an
ignited object. Drain fuel outdoors away from any
ignition sources. Use only approved fuel containers.
CAUTION
FOR LONG TERM STORAGE:
Close fuel shut-off valve and
store powerhead in an
upright position. Failure to
do so can cause oil leakage
over a prolonged period.
Follow the steps below to prepare your auger for storage.
Read your engine manual for detailed instructions on
preparing the engine for storage.
1. Run with gas stabilizer in fuel. Screen in carburetor will
glaze shut if gas stabilizer is not used before storage.
2. Drain the fuel system. Run the engine until it stops.
3. Change oil.
4. Remove spark plug, pour one (1) ounce of clean engine
oil into spark plug hole. Cover hole with a rag. Pull
starter handle slowly several times to distribute oil.
Install spark plug. Do not connect spark plug wire.
5. Clean entire auger.
6. Store your auger in a clean, dry building that is
inaccessible to children.
Page 7
ARDISAM