32 Degrees Rebel Xtreme 운영 매뉴얼 - 페이지 4

{카테고리_이름} 32 Degrees Rebel Xtreme에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 32 Degrees Rebel Xtreme 9 페이지.

페이지 인쇄

Internally, inspect the hammer/push strut assembly

and clean with warm water if necessary. Always lube

the internal parts after cleaning as described above.

Check the o-rings on the bolt and striker for wear and

replace if necessary. Standard tank o-rings work well on

the bolt, but don't use the black rubber type.

To ensure that your Rebel Xtreme will be operational at

the paintball field, there are a few parts and tools you'll

need. The most common o-ring in the Rebel Xtreme is

the "tank" o-ring. If you need to change any of these

o- rings, you'll probably need an o-ring pick to remove

the old ones. You really should keep several of these on

hand at all times.

Adjusting the Velocity:

To adjust the velocity of your Rebel Xtreme, screw the

thumb screw velocity adjuster (found in the bag of

parts) into the rear lower hammer plug. By adjusting

your thumb velocity screw clockwise you will increase

your markers velocity. By adjusting your thumb

velocity adjuster counter clockwise you will decrease

your velocity.

Disassembly / Reassembly

To properly clean and lubricate your Rebel Xtreme, you'll

need to remove the hammer, push strut,main spring,

and upper and lower plugs. After de-gassing the gun,

make sure the cocking handle is in the forward position.

This will guarantee that no air is left in the marker

before disassembly.

Remove the connecting pin located in the rear portion

of the main body. To do this apply pressure to the upper

and lower plugs, located on the rear of the marker.

While pressure is being applied remove the connecting

pin. After the connecting pin is removed release pressure

slowly. Now the lower plug will come out. Now that

the lower plug is out you gain access to the lower cham-

ber of the main body. Inside the lower chamber you will

find the spring strut, recoil pad, and main spring. After

removing these three parts, remove the upper plug.

Now remove the connecting pin, this is located on the

top of your marker. To remove this simply pull the pin

out through the top of the main body. After the con-

necting pin is removed you will now be able to remove

the upper and lower bolt from the main body

To remove the grip frame unscrew the two allen

screws that hold the grip frame to the main body.

To reassemble the marker simply follow the above

instructions in reverse order.

(Tech Tip) If your marker is rapid firing be sure to check

the lower bolt o-rings and trigger sear.