32 Degrees Rebel Xtreme Bedieningshandleiding - Pagina 4
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} 32 Degrees Rebel Xtreme. 32 Degrees Rebel Xtreme 9 pagina's.
Pagina afdrukkenInternally, inspect the hammer/push strut assembly
and clean with warm water if necessary. Always lube
the internal parts after cleaning as described above.
Check the o-rings on the bolt and striker for wear and
replace if necessary. Standard tank o-rings work well on
the bolt, but don't use the black rubber type.
To ensure that your Rebel Xtreme will be operational at
the paintball field, there are a few parts and tools you'll
need. The most common o-ring in the Rebel Xtreme is
the "tank" o-ring. If you need to change any of these
o- rings, you'll probably need an o-ring pick to remove
the old ones. You really should keep several of these on
hand at all times.
Adjusting the Velocity:
To adjust the velocity of your Rebel Xtreme, screw the
thumb screw velocity adjuster (found in the bag of
parts) into the rear lower hammer plug. By adjusting
your thumb velocity screw clockwise you will increase
your markers velocity. By adjusting your thumb
velocity adjuster counter clockwise you will decrease
your velocity.
Disassembly / Reassembly
To properly clean and lubricate your Rebel Xtreme, you'll
need to remove the hammer, push strut,main spring,
and upper and lower plugs. After de-gassing the gun,
make sure the cocking handle is in the forward position.
This will guarantee that no air is left in the marker
before disassembly.
Remove the connecting pin located in the rear portion
of the main body. To do this apply pressure to the upper
and lower plugs, located on the rear of the marker.
While pressure is being applied remove the connecting
pin. After the connecting pin is removed release pressure
slowly. Now the lower plug will come out. Now that
the lower plug is out you gain access to the lower cham-
ber of the main body. Inside the lower chamber you will
find the spring strut, recoil pad, and main spring. After
removing these three parts, remove the upper plug.
Now remove the connecting pin, this is located on the
top of your marker. To remove this simply pull the pin
out through the top of the main body. After the con-
necting pin is removed you will now be able to remove
the upper and lower bolt from the main body
To remove the grip frame unscrew the two allen
screws that hold the grip frame to the main body.
To reassemble the marker simply follow the above
instructions in reverse order.
(Tech Tip) If your marker is rapid firing be sure to check
the lower bolt o-rings and trigger sear.