360 BANDIT KINZE 3000 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} 360 BANDIT KINZE 3000에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 360 BANDIT KINZE 3000 6 페이지.

INSTALLATION INSTRUCTIONS

KINZE 3000

STEP 6

INSTALL SUPPORT STRAP

Remove the bolt on the bottom of the depth adjustment

assembly and discard.

Secure the top of the support strap

to the depth

adjustment assembly using the supplied 3/8" x 1-1/4" bolt

and washer from hardware kit #540615

bracketry is flush when bolt is installed.

Attach the support strap to the back holes on the extension

bracket with (2) 3/8" x 1-1/4" bolts and 3/8" flange nuts

from hardware kit #540615

. Tighten bolts with 9/16"

socket and wrench.

NOTE: The extension bracket may need lifted up to align

bolt holes. Tighten the bolt down until there is a flat

connection between the support strap and the depth

adjustment assembly.

Tighten the nyloc nuts that were left loose in STEP 5 with

3/4" socket and wrench securing the BANDIT extension

bracket to the row unit

STEP 7

REINSTALL CLOSING SYSTEM

Attach the tensioning spring on the closing system to the

spring hook on the BANDIT extension bracket

Align square holes in extension bracket with holes in closing

system arms. From the inside to the outside, using the thick

. Ensure all

spacer washer (one per side), slide supplied 2-1/4" carriage

bolt through all parts (carriage bolt head on the inside)

. Secure all parts with the previously set aside two-piece

bushing and provided 1/2" nyloc nut

socket. Adjust bushings according to OEM specs.

21 21

. Tighten with 1/2"

PAGE 4

STEP 8

PREPARE HOSE GUIDES

CUT

Using side-cutters, cut the two hose guides apart

Route the hose through the top two holes in the hose guide

Hose guides are labeled "L" left and "R" right

NOTE: When installing hoseguides on the row unit, left and

right are determined from the operators seat.