360 BANDIT KINZE 3000 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} 360 BANDIT KINZE 3000에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 360 BANDIT KINZE 3000 6 페이지.
페이지 인쇄INSTALLATION INSTRUCTIONS
KINZE 3000
BEFORE YOU BEGIN...
HELPFUL TOOLS
Hammer/Mallet
Wrench Sizes: 3/4", 9/16" and 15/16"
Socket Sizes: 3/4", 9/16" and 15/16"
Impact Driver/ Socket Wrench
STEP 1
REMOVE CLOSING WHEELS
2
1
3
Release spring 1 to remove tension from closing system.
Remove closing wheels with a 15/16" socket and wrench 2.
Retain the closing wheels, bolts, and nuts for re-installation
later in the instructions.
If present, remove insecticide attachment.
NOTES:
Removal of the closing wheels is necessary to facilitate the
ease of removing and reinstalling the spring.
If you are installing the optional chains kit, the bolts and
nuts 3 can be discarded but the bushings 4 need to be
kept.
PAGE 2
STEP 2
REMOVE CLOSING SYSTEM ARMS
7
4
5
6
Using a 9/16" socket, remove the bolt that holds the closing
wheel arm stop 5 to the row unit between the gauge
wheels.
NOTE: The gauge wheels may need to be held up to remove
the bolt.
Using a 3/4" socket remove the nut from the carriage bolt
that secures the closing system arms on the row unit.
Remove carriage bolt and remove closing system arms 6
from the row unit. Discard carriage bolt, nut and washers.
Retain two piece bushing 7.
Remove spring from closing wheel arm stop and set closing
wheel arm stop to the side.
NOTE: Retain closing wheel arm stop in a safe location for
installation of closing system without 360 BANDIT.