EarthWay 2100P Estate 조립 및 작동 지침 매뉴얼 - 페이지 4

{카테고리_이름} EarthWay 2100P Estate에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay 2100P Estate 6 페이지. Broadcast spreader
EarthWay 2100P Estate에 대해서도 마찬가지입니다: 조립 및 작동 지침 매뉴얼 (8 페이지)

페이지 인쇄

¼-20 Hex

Nut

Upper Handle

Assembly

¼-20 Lock

Nuts

13. c

aliBration

this stEP EnsurEs that your

you a corrEct starting Point to aPPly matErials at thE corrEct sEtting

turn thE sPrEadEr ovEr on to thE hoPPEr

push the Control Handle forward to #30, then push the shut-off plate forward until the

shut-off and the drop holes are fully open. Now tighten the #10 Screw on the Lower

Housing Clip firmly. Check to confirm calibration by closing the Control Handle, then

reopening to #30 and confirm that the drop holes are fully open.

14. Insert agitator to pinion shaft on inside of hopper.

Note: the position of flat side of the agitator. This pin

should be installed as shown.

PAGE 4

11. Install Upper Handle between Draw Bars. Insert ¼-20 x 1½" bolts through Draw Bar

and Upper Handle and secure with ¼-20 Lock Nuts. TIGHTEN BOLTS AND NUTS

NOW.

¼-20 x 1¾"

Carriage Bolt

12. Install Control Assembly onto Upper Handle by sliding the Control Assembly over

Upper Handle shaft then securing with ¼-20 x 1¾" Carriage Bolt and ¼-20 Hex Nut.

TIGHTEN BOLTS AND NUTS NOW.

akE surE to Position thE

andlE assEmBly as shown

¼-20 x 1½"

Hex Bolts

Draw Bars

2100P

. With the spreader resting on it's hopper

ontrol

roPErly adjustEd to givE

. n

ssEmBly

irE above thE

Open to #30

to calibrate

Shut-Off

#10 Screw

Control Wire

Lower Housing Clip

Larger Hole

raw

ar and

PPEr