EarthWay 2100P Estate Manual de instruções de montagem e funcionamento - Página 4
Procurar online ou descarregar pdf Manual de instruções de montagem e funcionamento para Espalhador EarthWay 2100P Estate. EarthWay 2100P Estate 6 páginas. Broadcast spreader
Também para EarthWay 2100P Estate: Manual de instruções de montagem e funcionamento (8 páginas)
Imprimir página
¼-20 Hex
Nut
Upper Handle
Assembly
¼-20 Lock
Nuts
13. c
-
aliBration
this stEP EnsurEs that your
you a corrEct starting Point to aPPly matErials at thE corrEct sEtting
turn thE sPrEadEr ovEr on to thE hoPPEr
push the Control Handle forward to #30, then push the shut-off plate forward until the
shut-off and the drop holes are fully open. Now tighten the #10 Screw on the Lower
Housing Clip firmly. Check to confirm calibration by closing the Control Handle, then
reopening to #30 and confirm that the drop holes are fully open.
14. Insert agitator to pinion shaft on inside of hopper.
Note: the position of flat side of the agitator. This pin
should be installed as shown.
PAGE 4
11. Install Upper Handle between Draw Bars. Insert ¼-20 x 1½" bolts through Draw Bar
and Upper Handle and secure with ¼-20 Lock Nuts. TIGHTEN BOLTS AND NUTS
NOW.
¼-20 x 1¾"
Carriage Bolt
12. Install Control Assembly onto Upper Handle by sliding the Control Assembly over
Upper Handle shaft then securing with ¼-20 x 1¾" Carriage Bolt and ¼-20 Hex Nut.
TIGHTEN BOLTS AND NUTS NOW.
m
akE surE to Position thE
h
andlE assEmBly as shown
¼-20 x 1½"
Hex Bolts
Draw Bars
2100P
is
. With the spreader resting on it's hopper
c
ontrol
.
P
roPErly adjustEd to givE
. n
ow
a
w
ssEmBly
irE above thE
Open to #30
to calibrate
Shut-Off
#10 Screw
Control Wire
Lower Housing Clip
Larger Hole
d
B
u
raw
ar and
PPEr