EarthWay 2100P Estate Manual de instruções de montagem e funcionamento - Página 2
Procurar online ou descarregar pdf Manual de instruções de montagem e funcionamento para Espalhador EarthWay 2100P Estate. EarthWay 2100P Estate 6 páginas. Broadcast spreader
Também para EarthWay 2100P Estate: Manual de instruções de montagem e funcionamento (8 páginas)
Imprimir página
Impeller
Gearbox Assembly
3. Install impeller onto pinion shaft. Insert 1/8"x 1¼" Cotter pin
through impeller then through pinion shaft. Use hole closest to the
gear box. Spread cotter pin to prevent from falling out.
Axle Bearing
Flat
Side
5. Install axle bearings to both Drawbars.
NOTE: Notch on bearings and in the
Drawbar line up. Bearings must go through
flat side of lower handle.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST
PAGE 2
Pinion
Shaft
⅛ x 1¼"
Cotter Pin
Notch
COAST WHEEL SIDE
¼-20 x 1¼"
Hex Head Bolt
¼-20 x 2"
Hex Head Bolt
6. Install lower handles onto axle to both sides as shown. Insert ¼-20 x 2" bolt through hole
in Draw Bar and through first hole in frame install locknut. DO NOT TIGHTEN. Next insert
¼-20 x 1¼" bolt through frame brace and through second hole in frame install locknut.
STEP. DO NOT OVER TIGHTEN.
SLIDE
4. Install gear box by inserting the pinion shaft into hole in center of hoppers
bottom. The word "FRONT" on the gearbox must point to F
hopper. Follow label instructions on hopper. Next, slide axle thru the gearbox
with the drive wheel hole positioned as shown in the drawings below.
Gearbox Assembly
Impeller
¼-20 Locknut
Gearbox
FRONT
ront
DRIVE WHEEL SIDE
Frame brace
Frame
Draw Bar
Shut-Off
of the
Flat Head
Screw