EarthWay 2170 조립 및 작동 지침 매뉴얼

{카테고리_이름} EarthWay 2170에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay 2170 6 페이지. Commercial broadcast spreader with side spread control
EarthWay 2170에 대해서도 마찬가지입니다: 조립 및 작동 지침 매뉴얼 (6 페이지), 조립 및 작동 지침 매뉴얼 (8 페이지), 사용 설명서 (8 페이지), 조립 지침 매뉴얼 (12 페이지), 조립 지침 매뉴얼 (10 페이지)

페이지 인쇄

2170 C

ommerCial

roadCast

ASSEMBLY and OPERATING INSTRUCTIONS

PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS

REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT

SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,

HELPFUL HINTS:

; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The

impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller

plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.

; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds

will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your

spreader thoroughly after each use. A coating of light spray oil on all metal parts inside & out will help prevent corrosion.

Wash between the shut off plate and bottom of the hopper. Do not use powdered materials.

; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.

33117

32100

Qty 1

Qty 2

36210

Qty 2

36214

31100

Qty 4

12152

12148

Qty 2

1. Remove and identify all loose parts from carton

(Qty 4 #36214)

1/4-20 X 1-1/2"

Phillips Panhead

preader

READ THE DIRECTIONS BEFORE ASSEMBLY

36300

32103

Qty 6

Qty 9

33108

36105

Qty 1

33109

Qty 1

31120

Qty 5

31106

Qty 2

(Qty 4 #36300)

1/4-20 SS Locknut

teChsupport

earthway

oCk

alt and

should not Be used in this spreader as

it will damage gearBox and Can void

se only granular materials

2. Position hopper on side. Install frame using (4) 1/4-20 x 1-1/2" Pan

Head Phillips bolts and (4) 1/4-20 nylon insert locknuts. First put bolts

through holes in frame then through holes in bottom of hopper. Secure

with locknuts. TIGHTEN THESE LOCKNUTS NOW - DO NOT

TIGHTEN WITH POWER TOOLS.

EarthWay

EV-N-SPRED

Rev. 3-10

SKYPE: EARTHWAY.TECH

Com

owdered materials

warranty

Pt# 52164

PAGE 1