EarthWay 2600A-Plus 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} EarthWay 2600A-Plus에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay 2600A-Plus 6 페이지. 40 lb broadcast spreader
EarthWay 2600A-Plus에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (6 페이지)

페이지 인쇄

Assembly and Operation Instructions

Attach the linkage pivot with ¼"-20 x 1 ½" bolt, MD flat washer, black spacer, and lock nut (shown above).

Step 10:

Turn the end of the control rod into the keyed shut-off plate under the hopper.

Step 11:

Install the ½" carriage bolt through the control rod and install the SM flat washer and hex nut on the

Step 12:

carriage bolt. Allow a loose fit for CALIBRATION instructions below.

CALIBRATION

Pull the Control Lever back to #30 on the Gauge,

then push the shut-off plate forward until the

shut-off and the drop holes are fully open. Now

tighten the Hex Nut on the ½" carriage bolt on

the linkage assembly. Check to confirm

calibration by closing the control lever, then

reopening to #30 and confirm that the drop holes

are fully open.

Insert agitator to pinion shaft on

Step 13:

inside of hopper.

Note: The position of flat side of the agitator.

This pin should be installed as shown.

2600A-PLUS_M52215_July2021

PAGE

PAGE 4