EarthWise TC70001 운영자 매뉴얼 - 페이지 7
{카테고리_이름} EarthWise TC70001에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWise TC70001 12 페이지. Tiller/cultivator
EarthWise TC70001에 대해서도 마찬가지입니다: 운영자 매뉴얼 (9 페이지)
페이지 인쇄
STARTING:
Make sure the wheel frame is raised before you
start the tiller. To raise the frame, pull out the lock
pin (Step A); rotate the wheel frame upward, beyond
the lock button on the back of the motor housing
(Step B); release the lock pin. The wheel frame will
be locked in place by the lock button. (See Fig. 3)
Secure the extension cord into the cord retainer (5).
The loop of the extension cord must be long enough
for the cord retainer to freely slide from one side to
the other. Plug the extension cord into the power
cord plug on the tiller.
Use the tiller/cultivator for breaking sod, preparing
seed beds, and for cultivating gardens and flower
beds. The tiller/cultivator can also dig small holes for
planting saplings or potted plants.
Move the tiller/cultivator to the work area prior to
starting the motor.
OPERATING
To lower wheel frame, push the lock button on back
of motor housing to release the frame. Lower the
wheel frame and pull out the lock pin on lower
handle section. Align lock pin to the hole in wheel
frame then release it to lock the wheel frame in
position. (See Fig. 2-2)
Hold the tiller/cultivator firmly while starting. The
tines will pull the tiller/cultivator forward during
operation. Lower the tines slowly with the guide bar.
To start the tiller/cultivator press and hold the safety
lock button (A) on the safety switch while pulling the
trigger lever (B) up and against the handle bar. The
motor will start and the tines will begin to rotate. To
stop the tiller/cultivator simply release the lever.
For breaking sod or deep tilling, allow the tines to
pull the tiller/cultivator forward to the end of your
arm's reach, then firmly pull it back toward yourself.
You will achieve the best results by repeatedly
allowing it to move forward and pulling it back.
By pulling the tiller/cultivator back towards yourself,
the tines will dig deeper and more aggressively.
To prevent tripping, take extra precautions when
moving backwards and when pulling the tiller/
cultivator back toward yourself.
If the tiller/cultivator digs deep enough to stay in one
spot, gently rock it side to side until it starts moving
forward again.
Never pass the tiller/cultivator over the extension
cord. Make sure the cord is always in a safe position
behind you.
When working on inclines always stand diagonally
to the incline to retain a firm, safe footing. Do not
work on extremely steep slopes.
7