Allied wagner 591004 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Allied wagner 591004에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied wagner 591004 10 페이지. Vehicle monitor kit

Terminal Description

New 4-position terminal, does not replace any existing terminal.

New 4-position terminal, replaces existing 2-position terminal that connects to unswitched power, BATT on ignition switch.

New 4-position terminal, replaces existing 2-position terminal that connects to RUN on ignition switch.

New 4-position terminal, replaces existing 2-position terminal (chassis ground).

Existing 2-position terminal, originally connected to J1939 terminating resistor pigtail.

6. Do not reconnect the existing wire connections to

the new terminal blocks yet.

7. Terminals "E", "F", and "G" are existing terminal

blocks. Refer to the electrical schematic for your

machine. Find the J1939 terminating resistor pig-

tail. It should have wires labeled "Green", "Yellow",

and "Shield" on the schematic, and look similar to

Figure 3.

8. Note the terminal numbers, and remove the J1939

terminating resistor pigtail. Retain pigtail if kit is

later removed.

9. Install the Vehicle Monitor in a convenient loca-

tion, near the console, terminal panel assembly,

or wherever the terminal blocks from step 4 are

mounted. Leave sufficient clearance for installa-

tion of wire harnesses and cables.

Figure 4 illustrates the monitor mounted to the

side of the console assembly in a Chipdozer. Your

installation may vary.

Use the self-tapping screws included in the kit

Table 2 Terminal Key

Figure 3 J1939 Terminating Resistor Pigtail Example

Remote Monitor

Figure 4 Vehicle Monitor mounted to Console

80-1056

Rev: 8-2014