Allied wagner 591004 Kurulum Talimatları Kılavuzu - Sayfa 4

Dokunmatik ekran Allied wagner 591004 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Allied wagner 591004 10 sayfaları. Vehicle monitor kit

Sayfayı Yazdır

Terminal Description

A
New 4-position terminal, does not replace any existing terminal.
B
New 4-position terminal, replaces existing 2-position terminal that connects to unswitched power, BATT on ignition switch.
C
New 4-position terminal, replaces existing 2-position terminal that connects to RUN on ignition switch.
D
New 4-position terminal, replaces existing 2-position terminal (chassis ground).
E
Existing 2-position terminal, originally connected to J1939 terminating resistor pigtail.
F
Existing 2-position terminal, originally connected to J1939 terminating resistor pigtail.
G
Existing 2-position terminal, originally connected to J1939 terminating resistor pigtail.
6. Do not reconnect the existing wire connections to
the new terminal blocks yet.
7. Terminals "E", "F", and "G" are existing terminal
blocks. Refer to the electrical schematic for your
machine. Find the J1939 terminating resistor pig-
tail. It should have wires labeled "Green", "Yellow",
and "Shield" on the schematic, and look similar to
Figure 3.
8. Note the terminal numbers, and remove the J1939
terminating resistor pigtail. Retain pigtail if kit is
later removed.
9. Install the Vehicle Monitor in a convenient loca-
tion, near the console, terminal panel assembly,
or wherever the terminal blocks from step 4 are
mounted. Leave sufficient clearance for installa-
tion of wire harnesses and cables.
Figure 4 illustrates the monitor mounted to the
side of the console assembly in a Chipdozer. Your
installation may vary.
Use the self-tapping screws included in the kit
4
Table 2 Terminal Key
Figure 3 J1939 Terminating Resistor Pigtail Example
Remote Monitor
Figure 4 Vehicle Monitor mounted to Console
80-1056
Rev: 8-2014