Allied wagner 591004 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Allied wagner 591004에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied wagner 591004 10 페이지. Vehicle monitor kit

Testing

Required tool: Multi-meter

Make sure that the wire harnesses are not plugged

into the vehicle monitor kit before performing the

electrical tests detailed below. The test will ensure that

the wire harnesses are connected to the appropriate

terminals.

CAUTION

Equipment damage hazard.

Make sure the wire harnesses are not

plugged into the vehicle monitor prior to

reconnecting the batteries at the switch.

Closing the switch with the wire harnesses

incorrectly connected may cause equip-

ment damage.

80-1056

Rev: 8-2014

Electrical Test

1. Close the battery disconnect switch.

2. With the keyswitch in the "OFF" position:

a. Measure the voltage between terminals "C"

and "D". The multimeter should display 0 VDC.

b. Measure the voltage between terminals "B"

and "C". The multimeter should display

24 VDC.

3. With the keyswitch in the "ON position:

a. Measure the voltage between terminals "C"

and "D". The multimeter should display

24 VDC.

b. Measure the voltage between terminals "B"

and "C". The multimeter should display

24 VDC.

4. If any voltage readings vary from the values listed

above, troubleshoot the wiring. DO NOT plug in

the wire harnesses to the vehicle monitor until you

observe values as described above.