Allied wagner 591004 Handleiding voor installatie-instructies - Pagina 7
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Allied wagner 591004. Allied wagner 591004 10 pagina's. Vehicle monitor kit
Testing
Required tool: Multi-meter
Make sure that the wire harnesses are not plugged
into the vehicle monitor kit before performing the
electrical tests detailed below. The test will ensure that
the wire harnesses are connected to the appropriate
terminals.
CAUTION
Equipment damage hazard.
Make sure the wire harnesses are not
plugged into the vehicle monitor prior to
reconnecting the batteries at the switch.
Closing the switch with the wire harnesses
incorrectly connected may cause equip-
ment damage.
80-1056
Rev: 8-2014
Electrical Test
1. Close the battery disconnect switch.
2. With the keyswitch in the "OFF" position:
a. Measure the voltage between terminals "C"
and "D". The multimeter should display 0 VDC.
b. Measure the voltage between terminals "B"
and "C". The multimeter should display
24 VDC.
3. With the keyswitch in the "ON position:
a. Measure the voltage between terminals "C"
and "D". The multimeter should display
24 VDC.
b. Measure the voltage between terminals "B"
and "C". The multimeter should display
24 VDC.
4. If any voltage readings vary from the values listed
above, troubleshoot the wiring. DO NOT plug in
the wire harnesses to the vehicle monitor until you
observe values as described above.
7