Miele PW 6167 사용 설명서 - 페이지 21

{카테고리_이름} Miele PW 6167에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PW 6167 40 페이지.
Miele PW 6167에 대해서도 마찬가지입니다: 매뉴얼 (48 페이지)

페이지 인쇄

Commissioning the dispensing pumps

Before the liquid dispensing pumps can be used the

liquid agent must be drawn up into the system and

the amount to be dispensed set.

Dispenser calibration

The dispensers need to be calibrated to ensure the

dispenser pumps supply the correct amount of liquid

agent.

To calibrate the dispensers with the machine

switched off:

^ Press and hold the rotary dial in.

^ Then switch the machine on with the "On" switch.

Dispenser calibration ~ Main menu

Dispenser pump 1

Dispenser pump 2

Selection choice: Dispenser pumps 1 to 13

After selecting a dispenser pump the following

message will appear in the display:

Dispenser calibration ~ Dispenser pump 1

V: 100ml

t: 0s

The amount to dispense can be set between 0 and

9999 ml in 1 ml increments.

^ Press the 0/1 multi-function button and the

dispenser hose will start to fill. Press the 0/1 button

again to stop filling the hose.

^ Direct the hose of the dispenser pump being

calibrated into a suitable measuring flask.

Avoid contact with the skin and eyes, and

wear suitable protective clothing.

^ Press the A "Back" button to return to the main

menu.

P: no

0/1

Dispenser calibration ~ Main menu

Dispenser pump 1

Dispenser pump 2

^ Select dispenser pump.

Dispenser calibration ~ Dispenser pump 1

V: 100ml

t: 0s

^ Press multi-function button 0/1.

To stop the pump press the 0/1 button again, or it

will switch off automatically after a period of 60

seconds.

^ Measure the amount collected in the measuring

flask.

Dispenser calibration ~ Dispenser pump 1

V: 100ml

t: 30s

^ Enter this value in field "V:". Flow rate P in ml/min

will be calculated electronically.

^ Press the S "Save" button to save the values

measured in memory.

^ Reconnect the hose.

Cleaning and maintaining the dispensing system

The dispensing system should be flushed through

with clean warm water every two weeks and before

any longer down-times to prevent the risk of

blockages and corrosion.

^ The suction pipes should be cleaned through with

water.

^ Place the suction pipes in a container of hot water

(40 - 50°C).

^ Then use the dispenser calibration system to

operate each pump until the dispensing system is

thoroughly flushed through.

^ After reconnecting all parts check all connections,

hoses, dispensers and seals for leakages.

Optional modules

P: no

0/1

P: 200.0 ml/min

0/1