Miele PW 6241 사용 설명서 - 페이지 37
{카테고리_이름} Miele PW 6241에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PW 6241 46 페이지.
Miele PW 6241에 대해서도 마찬가지입니다: 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (44 페이지), 프로그래밍 지침 매뉴얼 (48 페이지)
페이지 인쇄
This machine must be installed by an
authorised technician only. In the UK any
gas heated machines must be installed
by a Gas Safe registered engineer.
,
This machine is not designed for
washing items which have been treated
with dangerous or flammable substances.
Transport packaging must be carefully
removed using suitable tools.
The machine must be level and secure after
installation (see installation diagram
supplied with the machine).
To avoid the risk of frost damage do not
install this machine in a room where there is
a risk of frost occuring.
Do not install the machine on carpeted
flooring as the carpet pile can hinder the
free flow of air into the ventilation gaps at the
bottom of the machine.
Transit fittings
Brackets "A" (2 on each side) are secured
with hex screws which have to be removed
using a suitable tool.
Transit fittings "B", (2 at the front adn 2 at the
back) are secured with 3 hex screws each.
These have to be removed on site before the
machine is commissioned for use.
M.-Nr. 06 572 495
Notes for the installer
To do so the access panel and the rear
panel of the machine have to be removed.
Unscrew the hex screws from the bottom
edge of the front access panel and then take
the access panel off.
Unscrew the hex screws from the back
panel and then take the back panel off.
The front plinth facing is screwed to the
back panel. The rear plinth facing is located
under the machine lid and has to be fitted
after the machine has been successfully set
up. Screws are supplied in the accessories
pack for this.
Store the transit fittings in a safe place for
future use. They will need to be refitted
should the machine every need to be
moved to another location.
Use a pallet lifter to move the machine
around the room.
The machine must not be moved without
all the outer panels in place.
37