Miele PW 811 설치 계획 - 페이지 10

{카테고리_이름} Miele PW 811에 대한 설치 계획을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PW 811 38 페이지.

Installation and planning notes

Electrical connection

The electrical connection must be carried out by a qualified

electrician who must ensure that all electrical work is carried out in

accordance with applicable electrical regulations and standards.



This washing machine must be connected to an electrical mains

supply that complies with local and national regulations. Please also

observe your insurance and energy supplier's regulations as well as

any workplace health and safety regulations.



The required voltage, rated load and fusing rating can be found on

the data plate on the washing machine. Before connecting the

machine to the electricity supply, please ensure that the mains supply

voltage complies with the values given on the data plate.

Connection to a supply voltage other than the one quoted on the

data plate can lead to functional faults and damage to the washing

machine.

If more than one voltage is quoted on the data plate, the washing

machine can be converted for connection to the voltages stated.



Conversion to a different voltage must only be carried out by a

Miele Professional Service technician or by an authorised service

technician. The wiring instructions given on the wiring diagram must

be followed.

The machine can either be hard-wired or connected using a plug-

and-socket. For a hard-wired connection, an all-pole isolation device

must be installed on site.

For hard-wired machines, connection should be made via a suitable

mains switch with all-pole isolation which, when in the off position,

ensures a 3 mm gap between all open contacts. These include

circuit breakers, fuses and relays.

If the mains supply cannot be permanently disconnected, the isolator

switch (including plug and socket) must be safeguarded against

being switched on either unintentionally or without authorisation.

Useful tip: We recommend connection to the power supply via a

suitable plug and socket which must be easily accessible for

servicing and maintenance work after the machine has been installed.

An electrical safety test must be carried out after installation and after

any service work.

PW 811 / PW 814 / PW 818