Allmatic BIOS1 설치 매뉴얼 - 페이지 11
{카테고리_이름} Allmatic BIOS1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmatic BIOS1 12 페이지. Battery charging kit
Allmatic BIOS1에 대해서도 마찬가지입니다: 설치 (2 페이지)
페이지 인쇄
7.2 Normal functioning:
Standby - Gate closed or after the switch on of the control unit
Opening phase
Closing phase
Gate closed by user during opening
Gate closed by user during closing
Gate stopped by an external event (photocells, stop)
Gate opened without automatic reclosing
Gate opened in partial opening position without automatic reclosing
Gate opened waiting for auto reclosing, last 10 seconds the dash will be replaced by the countdown
Gate opened in partial opening position waiting for auto reclosing, last 10 seconds the dash will be replaced
by the countdown
During the normal functioning and out from any menu, the pression of the DOWN[-] button lets you see the
number of cycles done, you will see units with dots on the bottom of display and thousand without dot,
another pression of DOWN[-] or MENU button let you to leave the cycles visualization
Visualized during the learning of transmitters
Visualized when memorized a new transmitter or at the and of a reset
Visualized when memorized a button of a transmitter already memorized
Visualized when a trasmitter is erased
Visualized during the learnign of strokes to indicate that the control unit is opening the gate and waiting for the
command of opening mechanical stop
Visualized during the learning of strokes to indicate that the control unit is clkosign the gate and waiting for the
command of closing mechanical stop
Visualized during the learning of strokes if there is an intervention of safety devices
Visualized when the control unit waits a transmitter signal, during the function of viewing of the memory
location.
Visualized when the transmitter is not stored on the memory, during the function of viewing of the memory
location.
Visualized when the control unit exits from the function of viewing of the memory location for inactivity.
Visualized during the first coupling with the Bluetooth device.
Visualized when the control unit is connected to a Bluetooth device
Visualized when Bluetooth device is disconnecting from the control unit.
7.3 Errors:
Impact sensor intervention
Safety edge intervention
Limit switches error (both opening and closing electrical limit switches busy in the same time)
Malfunctioning of photocells
Thermical intervention to preserve the control unit
Memory error
Full memory
Memory error during functions viewing memory location or cancellation of a single transmitter
The visualization of an error on the display persist until another command is given
6-1622241
rev.6
04/12/2018
ITA
ENG
FRA
ESP
DEU
POR
11 / 12