Allmatic BIOS1 BRT 설치 매뉴얼 - 페이지 11

{카테고리_이름} Allmatic BIOS1 BRT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmatic BIOS1 BRT 12 페이지. Programmable control board for barriers brt

8. Display and control unit state

8.1 Normal functioning:

Standby - Barrier closed or after the switch on of the control unit (no in open position).

Opening phase

Closing phase

Barrier stopped by user during the opening

Barrier stopped by user during the closing

Barrier stopped by an external event (photocell, stop)

Barrier opened without automatic reclosing

Barrier opened in partial opening position without automatic reclosing

Barrier opened waiting for auto reclosing, last 10 seconds the dash will be replaced by the countdown

During the normal functioning and out from any menu, the pression of the DOWN[-] button lets you see the

number of cycles done, you will see units with dots on the bottom of display and thousand without dot,

another pression of DOWN[-] or MENU button let you to leave the cycles visualization

Visualized during the learning of transmitters

Visualized when memorized a new transmitter or at the and of a reset

Visualized when memorized a key of a transmitter already memorized

Visualized when a trasmitter is erased

Visualized during the learnign of strokes to indicate that the control unit is opening the barrier and waiting for

the command of opening mechanical stop

Visualized during the learning of strokes to indicate that the control unit is closing the gate and waiting for the

command of closing mechanical stop

Visualized during the learning of strokes if there is an intervention of safety devices

Visualized when the control unit waits a transmitter signal, during the function of viewing of the memory

location.

Visualized when the transmitter is not stored on the memory, during the function of viewing of the memory

location.

Visualized when the control unit exits from the function of viewing of the memory location for inactivity.

8.2 Errors:

Safety edge intervention

Limit switches error (both opening and closing electrical limit switches busy in the same time)

Malfunctioning of photocells

Memory error

Full memory

Memory error during functions viewing memory location or cancellation of a single transmitter

The visualization of an error on the display persists until you press the key DOWN[-] or another movement command, whatever it is

6-1622245

rev.3

23/12/2016

ITA

ENG

FRA

ESP

DEU

POR

11 / 12