Allmatic BIOS1 BRT Kurulum Kılavuzu - Sayfa 11
Kontrol Ünitesi Allmatic BIOS1 BRT için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Allmatic BIOS1 BRT 12 sayfaları. Programmable control board for barriers brt
Sayfayı Yazdır
8. Display and control unit state
8.1 Normal functioning:
Standby - Barrier closed or after the switch on of the control unit (no in open position).
Opening phase
Closing phase
Barrier stopped by user during the opening
Barrier stopped by user during the closing
Barrier stopped by an external event (photocell, stop)
Barrier opened without automatic reclosing
Barrier opened in partial opening position without automatic reclosing
Barrier opened waiting for auto reclosing, last 10 seconds the dash will be replaced by the countdown
During the normal functioning and out from any menu, the pression of the DOWN[-] button lets you see the
number of cycles done, you will see units with dots on the bottom of display and thousand without dot,
another pression of DOWN[-] or MENU button let you to leave the cycles visualization
Visualized during the learning of transmitters
Visualized when memorized a new transmitter or at the and of a reset
Visualized when memorized a key of a transmitter already memorized
Visualized when a trasmitter is erased
Visualized during the learnign of strokes to indicate that the control unit is opening the barrier and waiting for
the command of opening mechanical stop
Visualized during the learning of strokes to indicate that the control unit is closing the gate and waiting for the
command of closing mechanical stop
Visualized during the learning of strokes if there is an intervention of safety devices
Visualized when the control unit waits a transmitter signal, during the function of viewing of the memory
location.
Visualized when the transmitter is not stored on the memory, during the function of viewing of the memory
location.
Visualized when the control unit exits from the function of viewing of the memory location for inactivity.
8.2 Errors:
Safety edge intervention
Limit switches error (both opening and closing electrical limit switches busy in the same time)
Malfunctioning of photocells
Memory error
Full memory
Memory error during functions viewing memory location or cancellation of a single transmitter
The visualization of an error on the display persists until you press the key DOWN[-] or another movement command, whatever it is
6-1622245
rev.3
23/12/2016
ITA
ENG
FRA
ESP
DEU
POR
11 / 12