Miele DA 188 작동 및 설치 지침 - 페이지 19

{카테고리_이름} Miele DA 188에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DA 188 28 페이지. Miele ventilation hood user manual

Installation

Adjusting depth

^ The depth of the unit ("T" in the

diagram) can be adjusted from

" to 14

means of the adjustable brackets..

^ Slightly loosen the screws holding the

brackets.

^ Pull the brackets out to the desired

depth "T".

^ Tighten the screws again.

^ To align the depth on the underside

of the hood, loosen the screws on the

angle plate and move it to the

position required.

^ If the range of adjustment is

insufficient, unscrew the bracket

completely, rotate it, and use the

longer side.

^ Tighten the screws again.

" (275 to 360 mm) by

To install a plywood backing

The whole weight of the installed

ventilation system has to be

supported by the mounting plates.

They must be firmly attached to stud

framing behind the drywall. If studs

are not available directly behind

both mounting plates, a plywood

backing (min. 2" (51 mm) thick)

spanning at least two studs must be

installed. Failure to adequately

support the weight as stated may

result in the ventilation system falling

off the wall, causing personal injury

and property damage.

(If plywood backing is not needed,

proceed to "Wall attachment".)

^ Determine and mark the top edge of

the appliance. It must be at least

S + 17

" (S + 450 mm) in order to

comply with the safety height (see

"Appliance Dimensions").