Miele DA 424 V EXT 작동 및 설치 지침 - 페이지 22

{카테고리_이름} Miele DA 424 V EXT에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DA 424 V EXT 40 페이지. With extended canopy
Miele DA 424 V EXT에 대해서도 마찬가지입니다: 제품 치수 (2 페이지), 운영 및 설치 매뉴얼 (36 페이지), 작동 및 설치 지침 (36 페이지), 작동 및 설치 지침 (36 페이지), 작동 및 설치 지침 (36 페이지), 작동 및 설치 지침 (40 페이지)

페이지 인쇄

Cleaning and care

A range of Miele branded cleaning and

conditioning agents are available to

order through your Miele Dealer /

Chartered Agent, the Miele Spare Parts

Department, or via the internet on

www.miele-shop.com.

Before carrying out any cleaning

or maintenance work, disconnect the

cooker hood from the mains supply.

Halogen lamps get very hot

during use and remain hot for some

time after being switched off. The hot

lamps are also susceptible to

damage from damp cleaning. Wait a

few minutes after switching off before

commencing cleaning.

Housing

General notes

The surfaces and controls are

susceptible to scratches and

abrasions. Please observe the

following cleaning instructions.

^ All external surfaces and controls can

be cleaned with warm water and a

small amount of washing-up liquid

applied with a well wrung-out soft

sponge or cloth.

^ Wipe the surfaces dry using a soft

cloth.

Do not use too much water when

cleaning the controls. Water could

penetrate into the electronics and

cause damage.

Avoid:

– cleaning agents containing soda,

acids, chlorides or solvents,

– abrasive cleaning agents, e.g.

powder cleaners or cream cleaners

and abrasive sponges, as well as pot

scourers or sponges which have

been used previously with abrasive

cleaning agents.

These will damage the surface

material.

Important for appliances with

stainless steel housing

(This infomation does not apply to the

controls).

Stainless steel surfaces can be cleaned

using the Miele E-cloth, or with a

proprietary non-abrasive cleaning

agent designed specifically for use on

stainless steel.

To help prevent re-soiling, a

conditioning agent for stainless steel

can also be used. Apply sparingly,

following the instructions on the label.

If too much conditioning agent is

used traces of it may appear in the

area where the canopy rises and

falls.