Cleaning and care
A range of Miele branded cleaning and
conditioning agents are available to
order through your Miele Dealer /
Chartered Agent, the Miele Spare Parts
Department, or via the internet on
www.miele-shop.com.
,
Before carrying out any cleaning
or maintenance work, disconnect the
cooker hood from the mains supply.
,
Halogen lamps get very hot
during use and remain hot for some
time after being switched off. The hot
lamps are also susceptible to
damage from damp cleaning. Wait a
few minutes after switching off before
commencing cleaning.
Housing
General notes
The surfaces and controls are
susceptible to scratches and
abrasions. Please observe the
following cleaning instructions.
^ All external surfaces and controls can
be cleaned with warm water and a
small amount of washing-up liquid
applied with a well wrung-out soft
sponge or cloth.
^ Wipe the surfaces dry using a soft
cloth.
Do not use too much water when
cleaning the controls. Water could
penetrate into the electronics and
cause damage.
22
Avoid:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners or cream cleaners
and abrasive sponges, as well as pot
scourers or sponges which have
been used previously with abrasive
cleaning agents.
These will damage the surface
material.
Important for appliances with
stainless steel housing
(This infomation does not apply to the
controls).
Stainless steel surfaces can be cleaned
using the Miele E-cloth, or with a
proprietary non-abrasive cleaning
agent designed specifically for use on
stainless steel.
To help prevent re-soiling, a
conditioning agent for stainless steel
can also be used. Apply sparingly,
following the instructions on the label.
If too much conditioning agent is
used traces of it may appear in the
area where the canopy rises and
falls.
Drukuj stronę