Burgtec STRATA 360 사용자 설명서 - 페이지 3

{카테고리_이름} Burgtec STRATA 360에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Burgtec STRATA 360 10 페이지.
Burgtec STRATA 360에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (10 페이지), 문제 해결 매뉴얼 (10 페이지)

페이지 인쇄
Burgtec STRATA 360 사용자 설명서
Initialisation
1.
Press & hold the switch until the legs are fully retracted - this is the END STOP position. Release
the switch
2.
Immediately press and hold the switch for approx. 6 seconds. The legs will travel out 5mm and
then retract back to the END STOP position.
3.
It may be necessary to perform the intialisation process twice as the system can be in different
modes at start up.
4.
The legs are now initialised.
5.
Initialisation may be required after a power interruption or relocation of the desk.
Setting memory positions - DPG1C
- The DPG features 4 memory positions.
- To set a memory position adjust the desk to a preferred position and press the "Star" button for
2 seconds.
- The light strip will now flash white two times to indicate that saving the position is in progress.
- When the light strip becomes static white, the position is saved.
- The display will indicate this saved position with a star and a number of the position.
Error codes in
CBD6s
E53-E64
E41-E52
E01
Strata 360
Troubleshooting Manual
Cause
COLLISION
OVERLOAD
INITIALISATION
Scan QR Code
for More Information