Miele DAG 1000 작동 및 설치 지침 - 페이지 5

{카테고리_이름} Miele DAG 1000에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DAG 1000 16 페이지. External blower
Miele DAG 1000에 대해서도 마찬가지입니다: 작동 및 설치 지침 (40 페이지)

페이지 인쇄

d) Before connecting the appliance

to the power supply make sure that the

voltage and frequency listed on the

data plate correspond with the

household electrical supply.

This data must correspond to prevent

appliance damage. If in doubt consult a

qualified electrician.

e) Installation work and repairs

should only be performed by a qualified

technician in accordance with all

applicable codes and standards.

Repairs and other work by unqualified

persons could be dangerous.

f) Only open the housing as

described in the enclosed "Installation

diagram" and in the "Cleaning and care"

section of this manual. Under no

circumstances should any other parts

of the housing be opened. Tampering

with electrical connections or

components and mechanical parts is

highly dangerous to the user and can

cause operation faults.

g) Before discarding an old

appliance, disconnect it from the power

supply and remove the power cord to

prevent hazards.

Use

Do not use a steam cleaner to clean

the appliance. Steam could penetrate

electrical components and cause a

short circuit.

IMPORTANT SAFETY INSTRUCTIONS

Installation

,WARNING

TO REDUCE THE RISK OF

FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS,

OBSERVE THE FOLLOWING:

wiring must be done by qualified

person(s) in accordance with all

applicable codes and standards,

including fire-rated construction.

combustion and exhausting of gases

through the flue (chimney) of fuel

burning equipment to prevent back

drafting. Follow the heating equipment

manufacturer's guideline and safety

standards such as those published by

the National Fire Protection Association

(NFPA) and the American Society for

Heating, Refrigeration and Air

Conditioning Engineers (ASHRAE), and

the local code authorities.

wall or ceiling, do not damage electrical

wiring and other hidden utilities.

vented to the outdoors.

used to install the ductwork must be

made of approved non-flammable

materials.

,WARNING

TO REDUCE THE RISK OF

FIRE USE ONLY METAL

DUCTWORK.

a) Installation work and electrical

b) Sufficient air is needed for

c) When cutting or drilling into the

d) Ducted hoods must always be

e) Any fittings, sealant, or materials