Miele Imperial DWA 956-2 EX 작동 및 설치 지침 - 페이지 23

{카테고리_이름} Miele Imperial DWA 956-2 EX에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele Imperial DWA 956-2 EX 37 페이지.

– Drill 4 further holes 8 mm Ø through

the now fitted retaining plate.

– Provide the two top holes with S8

plugs and 5 x 40 mm screws, the

two bottom holes with S8 R60 plugs

and 5 x 60 mm screws . Screw the

bottom screws in only loosely so that

they can later be used to secure the

vapour canopy.

– Hold retaining plate B up to the wall

and push up until directly below the

ceiling. Use the notches and the

centre line to align it horizontally.

Mark the positions for the holes to be

drilled on the wall.

– Drill four 6 mm Ø holes into the wall,

and push the S6 plugs into the holes.

– Screw on the retaining plate with four

4 x 30 mm screws and four 4.3 mm

washers.

Retaining plate C only needs to be

fitted if dimension Y is greater than 400

mm. It provides greater stability for the

extension piece.

– Hold the retaining plate C at a maxi-

mum distance of 400 mm from the

ceiling and use the two notches to

align it with the centre line. Mark the

position of the two drill holes.

– Drill two 6 mm Ø holes into the wall,

and press the S6 plugs into the

holes.

– Screw on retaining plate C with two

4 x 30 mm screws and two 4.3 mm

washers.